AK gunsmith near Spring Hill

[cch2a]

I am in need of a reasonable gunsmith to install a standard AK trunnion on my M92 SBR. I would like to have options on standard AK stocks. I am in Spring Hill area.

[RC3]

closest one I can think of is Tom in franklin. He's the owner of lock stock and barrel. He does damn fine work, but he has a LONG waiting list

[Smith]

Just drill and tap the rear receiver. Pretty much everything aftermarket uses that pattern anyway.

[Smith]

Btw - everything you need to drill and tap the receiver you can get from CNC Warrior stay here. http://www.cncwarrior.com/category-s/1513.htm?searching=Y&sort=5&cat=1513&show=16&page=3

[JohnC]

4 minutes ago, Smith said:

Btw - everything you need to drill and tap the receiver you can get from CNC Warrior stay here. http://www.cncwarrior.com/category-s/1513.htm?searching=Y&sort=5&cat=1513&show=16&page=3

Whats a good threading kit that could I use to thread the barrel on a RWC IZ-132Z Saiga 7.62x39?

I had asked before, but never got around to buying the kit and doing it and now have forgotten what kit to get.

My rifle.

[Smith]

Whats a good threading kit that could I use to thread the barrel on a RWC IZ-132Z Saiga 7.62x39?

I had asked before, but never got around to buying the kit and doing it and now have forgotten what kit to get.

My rifle.

This is what I have used on numerous guns including many Saiga's. http://www.cncwarrior.com/AK-47-14x1LH-Barrel-Threading-Kit-p/25145.htm

Some Saiga's are already threaded under the hood. Just be careful not to cut too deep when removing the hood. Just take a Dremel with a cut off wheel and cut down into the hood right up against the fsb and it usually comes off pretty easy. Usually they are just tack welded in one or two spots. The paint makes it look like one piece.

Also, some fsb are already drilled for the FH retaining pin. Take a punch and tap in the area it should be and usually the plug weld will start breaking loose under the paint. If not, it's not hard to drill the holes.