Mill a p320 slide

[Dustbuster]

Do we have a resident expert or can anyone suggest who can mill a P320 slide so it can accept a RMR or red dot sight etc?

the plate supplied by Trijicon sits in the dovetail for the rear site,which I don't think it is feasible,please advise all suggestions truly appreciate it thanks Edited January 3, 2016 by Dustbuster

[LawEnforcementSalesTN]

I'm close DB, my contact got his slide back so I subsequently lost access to the RMR to finish things up... it's very close.. I'm not going to run one and just haven't wanted to drop the $400 to get a RMR to finish.

 

There's a few out on the web who do this but I know they're backed up 2-3 months.  If you can spare 3-4 weeks and wouldn't mine loaning me your RMR, I'll finish the programming and would mill your slide for free when ready. 

[Dustbuster]

i did some checking, galloway precision in NC is punching em out at 125.00 plus theyll add tall suppressor sights for an addl 75.00. apparently they have it down to a science, just send the slide by itself and theyll do the rest


Sent from my iPhone using Tapatalk, its either this or smoke signals! Edited January 17, 2016 by Dustbuster