gunsmith recommendation to chop a barrel and thread?

[broylz]

I am in gallatin and am in need of a gunsmith who can chop a couple inches off of my m&p10 barrel and thread it for a brake.

Who would you guys recommend? Wouldn't mind shipping if I need to but would prefer not to...

[Smith]

I wouldn't do that with an m&p10. It's a thin barrel and there isn't enough material to thread. That's why the factory barrel flares at the end for the fh. Also the m&p uses a proprietary barrel so if it gets messed up, you're out of luck. Edited December 25, 2014 by Smith

[173rdABN]

If you really need it done, mike Dresner in oak ridge. Goes by lawenforcementsales on here. Hands down. Wouldn't have a higher recommendation.

[broylz]

I got the compliant version with the bull barrel so that I could chop it down.

[Smith]

I got the compliant version with the bull barrel so that I could chop it down.

Then you're golden! Sam Hoster would do an excellent job for you. http://legallyarmed.com/complete.htm