SBR engraving for a Glock17 in a Roni PDW set up?

[Stainless]

I just got my form1 back for this conversion. Does anyone have a suggestion as to where I should engrave my Glock?

 

Thanks!!

[Capbyrd]

Anywhere you would like on the frame.  

[173rdABN]

Bring it to Mike Dresner in Oak Ridge. Hell, I'll even drive. I like visiting him. Got back from a full days trip yesterday actually. Had him engrave my MP5 and SBR AR lower while I was there. He uses his CNC machine and it goes a great job.

[Stainless]

Bring it to Mike Dresner in Oak Ridge. Hell, I'll even drive. I like visiting him. Got back from a full days trip yesterday actually. Had him engrave my MP5 and SBR AR lower while I was there. He uses his CNC machine and it goes a great job.

 

 

•  

Really?  btw, can he engrave polymer? I have a UMP with crappy engraving that needs to be cleaner and deeper.

[173rdABN]

I don't see why he couldn't. I can text him and ask. Or I'll have him chime in here. I think its $35. but don't quote that. ha.

[Mark A]

Bring it to Mike Dresner in Oak Ridge. Hell, I'll even drive. I like visiting him. Got back from a full days trip yesterday actually. Had him engrave my MP5 and SBR AR lower while I was there. He uses his CNC machine and it goes a great job.

Engraved a couple for me. Did a great job. Send him a message. If he says it can be done then he can do it.

[LawEnforcementSalesTN]

 

•  

Really?  btw, can he engrave polymer? I have a UMP with crappy engraving that needs to be cleaner and deeper.

 

 

Howdy Stan, you ever get that K-pack firing?

 

I can engrave just about anything but I can't pick up an existing engraving on the CNC.. I can most definitely make a new one. I'm sure there's hand engravers that can trace and do nice job if you have something you need made deeper.  

 

Keep in mind the ATF only requires .003 which is litterally about the thickness of a sheet of notebook paper... I usually will allow it make a few passes until it looks even but I don't like going too deep unless the font is a decent size... most my NFA I'll use a letter height of around .110-.120" (Michael Dresner would take about an inch of width across to give an idea) .....depth is usually around .005-.01... it's not as pronounced as some .. I can can deeper no problem at all it's just the bits I normally use only have a point that starts to widen out the deeper you get... so I've found this works well and is still plenty for the requirements.

 

The polymer engraves wells too..

 

Glocks I usually engrave the bottom side of the trigger guard or bottom rail.

 

The laser engravers give you the best finish but I'm always firing up the HAAS to engrave something for someone ;o)

 

Kris is right, it's $35 for standard NFA engraving plus any shipping if it's not a drop off/pick up..If your (or anyone for that matter up your area needs anything) I most definitely authorize him to be the transport anytime ;o)

 

Happy to help,

 

 

Thx guys

Edited November 26, 2014 by LawEnforcementSalesTN

[Stainless]

Yes on the K pack. Seems that the trip lever was hitting a spring thus not allowing it to fully depress. I should have it back this week.