7mm Rem Mag

[RED333]

I picked up a mold from NOE, 285 150 gr FN

Cast, powder coated and gas checked.

Loaded to OAL of 3.15,

Browning A Bolt, 1:9.25 twist, targets were at 25 yards.

My rifle and scope are zeroed for a diff round so point of impact are off.

1st target I was aiming at the center, 2nd and 3rd targets I aimed top center.

Rifle(no it is not wrong handed) is for us correct handed shooters.

[url=http://s896.photobucket.com/user/redintn/media/Left%20handed%207mm%20mag/abolt1_zps3dccd5c2.jpg.html][/URL]

Boolits and loaded round

[url=http://s896.photobucket.com/user/redintn/media/NOE%20150%20gr%20FN/NOE150grside_zpscd8a2d9d.jpg.html][/URL]

 

[url=http://s896.photobucket.com/user/redintn/media/NOE%20150%20gr%20FN/40gr_zpscd7ac38e.jpg.html][/URL]

 

[url=http://s896.photobucket.com/user/redintn/media/NOE%20150%20gr%20FN/41gr_zps0d106b42.jpg.html][/URL]

[url=http://s896.photobucket.com/user/redintn/media/NOE%20150%20gr%20FN/45gr_zpsbdc44ef6.jpg.html][/URL]

I am going to try to stretch her legs this after noon at 100 yrds.

I very happy how this boolit is doing so far.

 

Edited to remove load data

Edited July 27, 2014 by RED333

[Sidinman]

Lookin good there Red.

[RED333]

Well I have been told that I am looking for trouble with reduced loads in the 7mm Rem mag.

Seems that SEE or secondary explosion can happen, it starts as just some of the powder

will burn, leaving the rest to smolder. then the rest fires and it causes a large BOOM.

It will break rifles, hurt you and just make a good day go bad fast.

So DO NOT USE MY LOAD DATA, it is bad.

OP edited

Edited July 27, 2014 by RED333