Polymer 80% lowers

[Dolomite_supafly]

I just seen this and thought it was neat for those are the DIY types. The kit, with jig, is $100 and includes about $25 worth of tools.

 

Rather than the typical aluminum 80% lower these are polymer which makes it a lot easier to finish.

http://polymer80.com/

[10-Ring]

I like the concept but IMO it should be about $40 cheaper.  I see no point in paying $80-100 for a DIY setup when polymer lowers have been going for as low as $50-75 lately.  Unless you are reading into avoiding 4473 forms then I don't see the point. 

Edited February 6, 2014 by 10-Ring

[Oh Shoot]

I like the concept but IMO it should be about $40 cheaper.  I see no point in paying $80-100 for a DIY setup when polymer lowers have been going for as low as $50-75 lately.

 

Aluminum ones can be had for under $75 lately.

 

Even though it looked to be "improved", I sold my brand new replacement Omni lower today to a gun shop for $30, I'm done with 'em.

 

- OS

Edited February 6, 2014 by Oh Shoot

[Clod Stomper]

Take a look at these. http://www.eparmory.com/Default.asp

According to a YouTube video, these seem stronger. I've ordered a couple "blems" and they seem pretty strong.

At this point, I would not buy any more blems. The regular 80% are now $50 (they were 100 when I bought mine) and the "blem" is often the takedown pin hole being mis-drilled.

I haven't finished one yet, but I hope to in a few days.

Will

[Static_USMC]

Deleted Edited February 15, 2014 by Static_USMC

[itchytriggerfinger]

If any of you have any questions about EP Lowers shoot me a PM. I'm a dealer but I don't want to break any forum rules so I don't push it here.