Xtreme 115 gr. 9mm load data needed

[gearyr]

I bought 1000 of the Xtreme 9mm, 115 grain plated bullets at the Hendersonville gun show. The only powder I have a lot of right now is Power Pistol. So if any one has any load data using a plated bullet and Power Pistol let me know. Also, I have contacted Alliant. The gave me a cast lead bullet data. Max load of Power Pistol 5.5 grains. But no oal. Thanks, gearyr

Edited November 27, 2013 by gearyr

[Static_USMC]

Title says "155gr"

[ttocswob]

My limited experience was with 115g Berry's plated in 9mm. I followed the "cast bullet" advice which resulted in poor accuracy. I later read that loads should be more in line with jacketed bullet data than cast. YMMV

[gearyr]

Well I have loaded thousands of 9mm 115 grain FMJ with 6.0 grains of Power Pistol. Never had any problem with them. And the oal at 1.120. So I will load up 50 of the Xtreme bullets and see how they shoot. Thanks, gearyr

[expendable]

This is off of X-treme's site:
- Our Copper Plated Bullets can be run at mid-range jacketed velocities or higher end lead velocities. We do not recommend velocities over 1500 FPS (Feet Per Second) and only a light taper crimp.
Any velocities over 1200 FPS we recommend either our Heavy Plate Concave Base or Hollow Point products for superior accuracy. We do not recommend velocities over 1500 FPS (Feet Per Second) and only a light taper crimp.

Koz Edited November 29, 2013 by expendable