Comp-Tac CTAC C clip adjusment

[Guest db99wj]

As many know I use the Comp-tac CTAC holster, I use a standard clip on the front and a C clip on the back. One of the problems I have had is that the C clip will not stay on my belt securly, especially if I am not wearing my belt very tight or when I have to drop the pants for well ummm to take care of business. It is not a major problem and my gun was always secure when my belt was fastened. It was more of a problem when I didn't have my belt fastened to take care of the buisness mentioned above. So I have heard of others on here making kydex holsters and manipulating kydex so I gave it a try. I noticed that the top of my belt would not be in the clip it would be angled out, the bottom of the belt in the clip, the top out if that makese sense. Part of the problem is where I wear the holster and that area is right on my hip bone, so it makes a sharp turn. I used a lighter and heated up the top of the clip and then gently used preasure to bend the top part down. I did this several times until it "snapped" when I put the belt into it. I then put it in the freezer for a couple of hours to cure it, not sure if I needed to do it, but I did anyway. I might do it to the other C clip I have and replace the front. Here is some before and after crappy pics.

Before: You notice the Clip is straight.

After, see it curving down

Now it stays secure, even when it's sitting by my feet!