.311 cast for 30/30

[xd shooter]

Anybody Have any flat nose boolits they can share somewhere in the 150 to 170 gr range? I'm finally getting ready to try out my 336.

I prefer un lubed & unsized as I have my own home made lube to use.

I just want a few boolits to load & try to see what mold I would like to have..

Edited October 27, 2012 by xd shooter

[RED333]

Caster will chime in on this, I have some pointy things, but you wont want them.

[I_Like_Pie]

I am more interested in that homemade lube that you have. I remember you talking about it last time we met, but didn't know if you had made the jump. Let me know and I may want to buy some from you.

[Caster]

Make it yourself! It's fun.

http://www.tngunowners.com/forums/topic/50652-lets-make-our-own-bullet-lube/

[xd shooter]

Haha Matt I wanna know a little more about it too. I did finally get the sizer cleaned from the other lube I was using & it is full of my home made lube now.

I just need to get busy & lube some to try!!

You don't have a good flat nose .311 mold??

[I_Like_Pie]

I have a lee round nose labeled as .309 but drops a little larger. Works low velocity though 30/30 no problem. Only snafu is that it is single cavity and takes forever to fill the bucket.

[xd shooter]

Mine sluggs at .308- .309 & is a 336. Does your round nose feed well in a levergun??

[I_Like_Pie]

Yeah...The design was, I suspect, to be able to shoot old 30 cal mil surps, but works just fine in the30/30