Jump to content

Kel Tec PF9


Recommended Posts

Posted

I've been calling a few shops around my area (Hermitage), and I can't seem to find a shop that carries the Kel Tec brand.

I'm trying to find a Kel Tec PF9. Any of you guys know a store that carries them? Thanks!

  • Replies 15
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Guest Bronker
Posted

Guns & Leather in Greenbrier for sure. May have some in the Hendersonville store too.

D&T Arms on Rivergate Pkwy has some as well.

Both places are nice shops with nice selections and good guys.

Guest MERRILL
Posted

Dropkick, if you haven't shot one, I suggest you do so before purchasing one. I qwned one for a short while. The trigger pull was hard and it had a long reset. If you do not release the trigger completely, it will not fire the next round. The ejector broke after less than 100 rounds. Of course this was just my experience and the gun may have been a lemon.

Posted

Thanks for the heads up Bronker. I went to the Hendersonville store and didn't see any. I'll have to head to the Greenbrier store.

I'll look into that Merrill, thanks for letting me know.

Posted

I just picked up a PF-9 for CC. Haven't had a chance to get any range time in yet, but I understand it is a bit snappy. I think with a set of Hogue slip on grips, it will help. I paid $290 out the door for mine, though I could have gotten it cheaper if I wasn't in such a hurry.

Owners group

KTOG Forum - Index

Posted

I picked up a pf9 last week. I ran around 150 rounds through it with no problem. I didn't have any complaints about the trigger. It is a little snappy..... like a small frame .38 in my opinion. Nothing that isn't manageable unless you are recoil sensitive.

Guest rebeldrummer
Posted

I just bought one of these last week on the reccomendation of Bill and Mike at Bills Outpost in Maryville TN. Two of the local LE divisions have been buying them as their backups, or so I am told by a few guys around here. Alot of good feedback from these people as well. Affordable and dependable is the general word.

Guest Aces&8s
Posted

I have had my PF-9 for a couple of years now, and really like it. It is snappy, but less so than my LCR with +P rounds. I have had one FTE, but I chalk that up to the ammo, since I had the same problem with my Ruger P95 with that same box of ammo. KT does not recommend shooting a lot of +P through the PF-9, so I practice with standard pressure rounds, and then run a mag or two of my carry ammo through it (I am using Corbon PowerBall 110 grain +P).

I can say that adding the Hogue grip, pinky extension, and the trigger shoe helped a lot with the handling of the gun. The pinky extension falls between my ring finger and pinky, but it seems to help keep the gun from twisting in my grip (like I said, it is snappy ;) ).

Posted

Thanks for the tips. I picked one up today at Guns & Leather and I shot the crap out of it with no failures.

It is snappy like some of you mentioned, but not too bad. My only complaint is that I shoot low with it, but after a few shots I was able to correct it.

After making the correction, I found that the PF9 is pretty damn accurate. In fact I was surprised at how well I was shooting with it.

I'll have to check out the Hogue grip GTV mentioned, because it did beat my hand up pretty bad after 200 rounds.

Thanks again for the tips.

Guest .45packer
Posted

I'm pretty sure The Reloaders Bench in Mt. Juliet is a Kel Tec dealer.

Posted
  Dropkick Murphy said:
I'll have to check out the Hogue grip GTV mentioned, because it did beat my hand up pretty bad after 200 rounds.

You'll want the Hogue Handall Junior. Put it on upside down so the smaller part of the front is below the finger groove. It's a HUGE help.

I also smoothed out the ridge in the trigger with an emery board. Ended up being a pretty comfortable shoot, but still not a range gun. :)

Enjoy!

Posted

Congrats on the purchase.

I really like my PF9. No failures so far. It chewed the palm of my hand up a little the first time I took it to the range. I took some 400 grit sandpaper to the rough, unfinished seams on the back of the grip, and that improved the comfort level tremendously while shooting this gun. It doesn't bother me at all now.

I find it to be very accurate, and very easy to carry. It disappears under a T-shirt.

Nice little gun that doesn't break the bank.

Guest Aces&8s
Posted
  JMB said:
You'll want the Hogue Handall Junior. Put it on upside down so the smaller part of the front is below the finger groove. It's a HUGE help.

Good point, JMB... I had forgotten that I put mine on upside down, too. Feels better and gives better access to the mag release. I might have to try the emery board, although after a few hundred rounds, the trigger on mine has smoothed out quite a bit

Also, when I first bought mine, I was shooting low and slightly to the left with it, primarily due to the trigger pull, I think. I just was not used to such a long pull on a semiauto. The more I practiced with it and learned how to stage that trigger, as well as installing the oversized trigger shoe, helped a lot in bringing my POI to the POA.

Posted

if any of you guys are interested(hope this doesnt violate terms) I have an M-TAC/Comp tac Minotaur Gladiator Holster they are new 80 + shipping, think I picked this one up for 69, its an OWB leather/kydex holster that tucks up against your body well, I've started solely pocket carrying my pf9, is anyone wants a great deal make me an offer via PM, I have the shipping option available.

WEBSITE: Outside Waistband Holsters - Minotaur Holsters - products new home - Minotaur Gladiator Holster

Posted
  MERRILL said:
Dropkick, if you haven't shot one, I suggest you do so before purchasing one. I qwned one for a short while. The trigger pull was hard and it had a long reset. If you do not release the trigger completely, it will not fire the next round. The ejector broke after less than 100 rounds. Of course this was just my experience and the gun may have been a lemon.

Ditto what he said. :)

Posted (edited)

Scroll down to the bottom of this page: GoldenLoki.com I recommend that every Keltec centerfire pistol have this done to it KEL-TEC DIY Reliability Prep On hardchrome KTs just make sure you clean the frame well and keep it lubed and cleaned. A pocket gun picks up all kinds of crud quickly even if you have it in a decent pocket holster.

I also afixed the trigger shoe to both of the ones that I have had and my KT 32. The wider trigger makes a huge difference. GoldenLoki.com KEL-TEC Trigger Shoe / Stop To do this well you should have access to a dremel to shape the trigger shoe better for your individual taste.

As far as grip goes you can get a bicycle inner tube that stretches tightly around the grip and cut it to fit. It still carries slim and confidently but the gun is a little easier to shoot at the range.

Edited by graycrait
clarification

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

TRADING POST NOTICE

Before engaging in any transaction of goods or services on TGO, all parties involved must know and follow the local, state and Federal laws regarding those transactions.

TGO makes no claims, guarantees or assurances regarding any such transactions.

THE FINE PRINT

Tennessee Gun Owners (TNGunOwners.com) is the premier Community and Discussion Forum for gun owners, firearm enthusiasts, sportsmen and Second Amendment proponents in the state of Tennessee and surrounding region.

TNGunOwners.com (TGO) is a presentation of Enthusiast Productions. The TGO state flag logo and the TGO tri-hole "icon" logo are trademarks of Tennessee Gun Owners. The TGO logos and all content presented on this site may not be reproduced in any form without express written permission. The opinions expressed on TGO are those of their authors and do not necessarily reflect those of the site's owners or staff.

TNGunOwners.com (TGO) is not a lobbying organization and has no affiliation with any lobbying organizations.  Beware of scammers using the Tennessee Gun Owners name, purporting to be Pro-2A lobbying organizations!

×
×
  • Create New...

Important Information

By using this site, you agree to the following.
Terms of Use | Privacy Policy | Guidelines
 
We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.