VZ Grips announces Custom 1911 Grip Screws

[DavidD]

"Our custom grip screws are handmade one at a time from stainless steel. Using a T-15 Torx

wrench for installation, you can easily add a custom touch to your 1911 and make your grips

look even better. Click here "

[strickj]

Looks like a set of hub caps!

[VERO1]

I am waiting until they come out with "spinners". Maybe some dubs after that?

[LngRngShtr]

OK someone just go ahead and make a set using the heads of the caliber the 1911 is in, .45 ACP for the classic carry .38 Super for the IPSC folks,.. .40 S&W for the IDPA guys maybe some .38Spl for the Bullseye crowd... not much thickness but that would be the "Dubs" of this evolution

Maybe smaller head screws and inletting the case heads as grip screw escutcheons

John

~~ looking at a few of the 3,000 10mms he has thinking " I have a T-15 driver...." ~~

[DavidD]

Man, you guys be hate'n...............

I'm not saying that I'd order a set but those on the upper left look pretty Good to me. I would be concerned about having to use the Torx wrench to tighten them up and also the possibility of stripping them out.

[MikeW]

On the right gun, I would use the bottom left screws. It is nice to have "optioins".

[Magiccarpetrides]

when there is nothing left to bling ;-D

not a bad idea though.

[strickj]

I am waiting until they come out with "spinners". Maybe some dubs after that?

When my gun stops shootin, my screws keep spinin

[Mike.357]

someone invented something to fill a need that did not exist before these came out.

They look nice but not for moi

[JPS]

Put little skulls on them so the Punisher fans will go for it..!

(Seriously, the ones on the left look ok, and I like the idea of using a Torx to get them on and off.)