Jump to content

Ammo advice needed for S&W snubbie...


Zulu Cowboy

Recommended Posts

Posted

I just picked up a new (pre-lock) J-frame, S&W Ladysmith .38 special...and I need to know what kinds of ammo would be best, for a self defense load? I've been researching a bit...and some folks seem to prefer the Remington 158-gr. LSWCHP +P. But I'm not sure I can safely shoot +P rounds out of this weapon.

Any ideas?

;)

Zulu Cowboy

pix57014421.jpg

  • Replies 17
  • Created
  • Last Reply

Top Posters In This Topic

Posted

You could checkout BuffaloBore.com they have two good non +p loads, a 125gn. jhp made by GoldDot, and what I like the 158gn. swchp, it's gas-checked (so as not to lead your barrel). I got some for my sister to shoot in her 3in. M34. Good stuff!! More "felt recoil" that the 125gn. load, but many a BG has been put down with that round!

Guest BEARMAN
Posted

Winchester Silvertip 125 gr. HP is a very good, non +p round, for the J-frame Smitty also.

Thats what I carry in my S & W 442.

Posted

I carry Hornady 125g XTP in mine. Also have some 110g Critical Defense. Neither is +p.

My snubby is a 20-something-year-old steel frame Model 36. I have shot UMC +p with no ill effects.

Listed muzzle velocity on the UMC +p is 925fps; the Hornady is 900fps - not much difference.

Posted

Contray to popular opinion, I try and run a light and fast bullet out of a snubby.

You lose a lot of velocity out of a short barrel and expansion with heavier bullets

is hit and miss. Winchester use to make a 95Grn. Silver tip +p that would expand

to .62 Caliber reliably out of snubbies, luckily I bought a bunch before they were

discontinued. I still carry those when I carry my Airweight and i just purchased

some Hornady 110 +p Critical Defense to try. I don't think you are going to get

enough velocity to promote reliabe expansion with JHP 125Grn or heavier bullets.

Of course opinions are like arm pits, everybody has a couple.

Posted

Since that gun has one purpose ie. self-defense I could only load it with Hornady Critical Defense ammo. If you are going to the range just remember to take it out before you shoot.

Guest truthsayer
Posted

I carry the Federal 158gr +p Nyclad in my snubbie.

Posted (edited)
Whatever's handy. I usually shoot wadcutters in mine. Would you want to be shot with a 38 wadcutter? I don't!!!

The owner of my LGS told me that he had seen a guy who was accidentally shot in the torso (gut) with a .38 wadcutter. Said it made a big hole and did a lot of damage. They called an ambulance as soon as it happened and the poor guy was dead (pretty much bled out) before emergency services could arrive.

I carry Hornady Critical Defense standard pressure in my Rossi snubbie with Hornady XTP standard pressure in the speed strip if I carry a reload (XTP is supposed to give deeper penetration but less reliable expansion - I'll eventually do a 'milk jug' test to compare for myself.) Mine will handle +P but I am not entirely convinced that +P gives that great an advantage in a snubbie over some of the newer, standard pressure loads designed for SD from a short barrel. Still, I am considering switching to something in +P for my reload. Again, I need to do some informal testing of my own.

You probably already know this but one thing to consider when loading a snubbie for SD is muzzle flash. I shot a few, different loads back to back to test for accuracy. I did this outside and it happened to be near dusk. I found that the XTP in standard pressure produces a fireball that is comparable to WWB JHPs in +P. Remington Golden Sabres in +P produced pretty much the same size fireball - all of them large and bright enough to impact night vision or be a distraction in low light. I fired the Critical Defense before these other rounds and honestly didn't even notice much muzzle flash - meaning reacquiring the target and getting off subsequent shots was quicker. Functional accuracy for SD from ten yards was comparable for all of the loads I tried.

That's a nice looking little shooter, by the way.

Edited by JAB
Posted

What's the model # and first few digits of the SN? It looks like the +P frame on your revolver, but I'll look it up in the SCSW for ya.

Posted
What's the model # and first few digits of the SN? It looks like the +P frame on your revolver, but I'll look it up in the SCSW for ya.

Smith & Wesson Model 60-7 Ladysmith...Serial# BFC59**

Thanks...

Zulu

Posted

According to the Standard Catalog of Smith & Wesson your revolver is not safe to use with +P ammo. It was made in 1990 and the change to the J magnum frame came with the 60-9 revision level in 1996.

You should stilck to standard pressure ammo.

Posted
According to the Standard Catalog of Smith & Wesson your revolver is not safe to use with +P ammo. It was made in 1990 and the change to the J magnum frame came with the 60-9 revision level in 1996.

You should stilck to standard pressure ammo.

You are so right!! I saw many, many j-frames blown-up in the late 80s ,early 90s, from guys trying to run +Ps , never know if it's the 50th rd. or the 500th rd. but they will blow!!!
Posted (edited)
According to the Standard Catalog of Smith & Wesson your revolver is not safe to use with +P ammo. It was made in 1990 and the change to the J magnum frame came with the 60-9 revision level in 1996.

You should stick to standard pressure ammo.

Thanks enfield...I think I'll do just that!

I sincerely appreciate you looking that up for me...I was just getting ready to drop some serious coin on a 1000 rd. case of +P.

You may have just saved me a trip to the ER, my friend!!

I owe you one...

Zulu Cowboy

Edited by Zulu Cowboy
Posted

Check with John at Eastside Gun Shop. He is doing variety o reloads for 38"'. I"ve been very pleased with the PD rounds and their range ammo.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

TRADING POST NOTICE

Before engaging in any transaction of goods or services on TGO, all parties involved must know and follow the local, state and Federal laws regarding those transactions.

TGO makes no claims, guarantees or assurances regarding any such transactions.

THE FINE PRINT

Tennessee Gun Owners (TNGunOwners.com) is the premier Community and Discussion Forum for gun owners, firearm enthusiasts, sportsmen and Second Amendment proponents in the state of Tennessee and surrounding region.

TNGunOwners.com (TGO) is a presentation of Enthusiast Productions. The TGO state flag logo and the TGO tri-hole "icon" logo are trademarks of Tennessee Gun Owners. The TGO logos and all content presented on this site may not be reproduced in any form without express written permission. The opinions expressed on TGO are those of their authors and do not necessarily reflect those of the site's owners or staff.

TNGunOwners.com (TGO) is not a lobbying organization and has no affiliation with any lobbying organizations.  Beware of scammers using the Tennessee Gun Owners name, purporting to be Pro-2A lobbying organizations!

×
×
  • Create New...

Important Information

By using this site, you agree to the following.
Terms of Use | Privacy Policy | Guidelines
 
We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.