Another Project.

[DJTC45]

I got an H&K SL8-6 not long ago from a member here. I did some research on what parts to get to make a "Poor man's" G36, I was going to send it to Tommy Built but he's not accepting any work. So I searched around and found some parts to get started with, just need a couple of more parts and send the SL8-6  Bolt out to be modified to a G36 Bolt to be able to use P-Mags and the H&K dbl. Stack Mags along with a G36 MagWell, a orginal G36 Bolt is $400+ and modify the original SL8-6 $100 so I'll go that route. Got the Stock in and the HDPS Stock Block also got a Tommy Built G36 Lower that takes AR 15 Triggers, I went with a Geissele SD-E Flat Trigger. Just got done fitting the Lower, need to work on the Stock Block a little and it will be good to go, then make sure that the Geissele Hammer clears everything inside if not then a little fitting will take care of that. Here's some of the parts, I'll post as I go along. Thanks for looking.

Edited June 22 by DJTC45
Added pictures.

[DJTC45]

Got it all tore down, just waiting on the other parts.

Edited June 22 by DJTC45

[BigK]

I've never been a fan of that stock...good upgrade!

[DJTC45]

Yeah, I never was a fan of thumb hole stocks never could get my grip to feel right when shooting them.

[DJTC45]

I've got some more parts coming tomorrow. They should be enough to start fitting everything up, and if all goes well I'll be able to test it with the H&K SL8-6 Mags. Then consecrate on getting the bolt modified to a G36 Bolt and get that Tommy Built G36 MagWell Conversion for using P-Mags, and the G36 Mags.

[DJTC45]

Got a few more smaller parts in today. Did some fitting on the Tommy Built AR Lower assembly, G36 Stock, and a few other parts. I got it mocked up just need to clean it up where I had to do a little fitting, but so far it's coming along.

Edited June 24 by DJTC45

[NoBanStan]

awesome! it really ticks me off that H&K stuff had to get import neutered. you shouldn't have to do any of this. can't wait to see the outcome #nomorefreehand

[DJTC45]

Got most of it done, not sure about the stock I may change it out to another style. Everything is put back together to check out the functionality and it's great, that Geissele SD-E Flat Trigger makes a world of difference in the pull, right around 4#. The Extended Bolt hold open functions as it should now all that is left is to get the SL8-6 Bolt modified to the G36 Bolt, get the Tommy Built AR MagWell to be able to run the double stack mags, and a low profile rail and it's done. More pictures to follow.