ad-closed Texan Reloaders

[Ridin1]

Texan FW 12g-$175. Will come with 4 dies of my choosing. If they’re not the right size for your load you can use a burr bit to make them bigger or add some epoxy to decrease the capacity. I have disassembled it to clean everything, lubricated the moving parts & tested it. Appears to be fully operational & ready for use. Nothing is broken or missing as far as I can tell but I’ve never used or even seen one before so...

I will only be selling 1 of the 2 following presses.

Center press: Texan Model M 11A 12g- $400. Press is extremely tight, no damage or visible excessive wear. Fully disassembled, thoroughly cleaned & lubricated. Will come with 4 dies of my choosing. 
 

Right press: Texan Model M 11A 12g-$350. Press is extremely tight, no visible damage or wear. Fully disassembled, cleaned & lubed. Will come with 4 dies. This press has been modified to improve the design of the rotating drum. I have also had to lap the drum to remove some minor gouging from where it appears a single pellet had been trapped between the drum & top plate. A few thousandths of an inch were removed which means the dies need to have the same amount of material removed from them. It’s priced cheaper since the new owner will have to lap the dies to fit. Which involves some 220 grit sand paper on a flat surface & carefully removing material until it’s the exact height of the drum. Takes a couple minutes tops. Once that’s done it obviously won’t need to be done again but any new dies will need to be lapped. I have loaded 480 shells with this press without issue.