Help needed

[Guest DubLtap]

What is the best thing to use to attach a pressure switch to the handle ?

Epoxy, two sided tape, what lasts...

Thanks

[Guest flyfishtn]

What is the best thing to use to attach a pressure switch to the handle ?

Epoxy, two sided tape, what lasts...

Thanks

What is the handle made of and what is pressure switch made of?

Gel Super Glue is good, only problem is it starts to melt plastics and rubbers which is not so bad if this is a long term solution.

I would go with double sided, 3M, high strength if you think you might want to move it.

[poak]

I would go with double sided, 3M, high strength if you think you might want to move it.

+1

[Guest Rando]

If you havent already I would go with a rubber band or two before anything to be sure of placement and if you dont stay with the rubber bands you cant beat good 3M double sided tape just make sure to clean both surfaces before applying it no oils etc. ( Yea I know -duh- but you would be surprised at how many wouldnt think of that the first time around) Good luck;)

[Westwindmike]

Bicycle inner tube cut into 1" widths works well on AR handguards.

[10Kilr]

Bicycle inner tube cut into 1" widths works well on AR handguards.

Took the words right out of my mouth. Great minds think alike, Mike.

[Daniel]

hook and pile fastners also work.

[Guest Clutch442]

Go to your local hobby store and get some servo tape. This stuff holds down servos in R/C vehicles. Stuff is evil, works awesome for holding anything down, and you can get it off if you need to.