SD9VE Trigger Guard Alteration

[MRSpivey]

I was wanting to know if altering (file/cut) my trigger guard (up by where it meets the flat area) by a few mm would potentially cause an issue down the road. The laser sight I have would fit much better if I filed a 90% angle into the top front curve so the back of the laser would sit in it nicely verses the back 90% edge of the laser hitting on the rounded guard. Y'all's input would be greatly appreciated.
 

 
Sent from my iPhone using Tapatalk

[Garufa]

The only issue it would cause is with resale value.

[MRSpivey]

The only issue it would cause is with resale value.

I'm not concerned about that. If it were something like a Dessert Eagle then there would be no question. LOL


Sent from my iPhone using Tapatalk

[MRSpivey]

Well... I did it.

 

 

 

Edited February 24, 2018 by MRSpivey