Tork Mag G Block

[Verne]

Earlier this year, like so many others, I saw a deal on a PSA 9mms upper listed for their dedicated lowers. After research it appeared it would work on a standard mil-spec lower. So I ordered one to find out for sure. To confirm it will pin to and work on a standard lower.

So then started the hunt for a magwell block for my SBR. After some searching I can across a video from this years Shot Show about a magwell block that would accept Glock mags. So I got on their pre-order list and Tuesday my York Mag G Block was delivered.

http://torkmag.com/g-block.html

It seems to be well made. Plastic with a metal ejector. It is a two piece design that uses a set screw to hold it in place. One in the front of the mag well and one at the rear. Installation was simple enough and instructions clear.

Yesterday I was able to put 50 rounds through it with out a problem. I used three different mags. Two17 round mags and one 33 round mag.

Now for the lone photo I took.

[Omega]

I've been eyeing those uppers, I keep deleting those emails but they keep sending them to tempt me.  Now you take away my only defense by making it way too easy to setup a standard lower 

[Murgatroy]

I am not sure I like the whole modifying the magazine part.

[Verne]

I am  not against Glocks but never really cared for them. I always said I would own a 17 at some point. So about a month ago I purchased a LEO trade in. I was already buying up mags for one anyway. 

I'm not too concerned about modifying the mags. I have done all 6 mags I currently have and haven't noticed any issue with them in the 17.