Glock 41

[TN357mag]

This pistol quickly became one of my favorite.... any othet 41 owners here ?

[TNMTBik3r]

41 MOS. I have since added Talon Grip tape but haven't touched anything else.

I may install a 3.5# connector at some point so it more closely matches my G34 trigger. Or even a full trigger group, haven't made up my mind yet.

One of the coolest factors of the G41 is the 9mm sized slide. The G41 fits my competition holster for my G34 without issue, if/when I want to use it. I actually shot both in USPSA the other month, just had to deal with the mag differences.

[TN357mag]

Other than night sights . , mine is also, stock as a clock...

The 41 replaced my 21  .. If they made a 21S .. I would own one .. 

[bucnball]

Nice looking ! What's the barrel length ? My old model 30 is feeling envious !

[TN357mag]

5.31 inches according to Glock .

Being that is a thinner slide .. and lighter slide , the pistol balances well .. points well .. 

[hipower]

4 hours ago, jonathon1289 said:

41 MOS. I have since added Talon Grip tape but haven't touched anything else.

I may install a 3.5# connector at some point so it more closely matches my G34 trigger. Or even a full trigger group, haven't made up my mind yet.

One of the coolest factors of the G41 is the 9mm sized slide. The G41 fits my competition holster for my G34 without issue, if/when I want to use it. I actually shot both in USPSA the other month, just had to deal with the mag differences.

She looks great! I almost miss it. lol

[TNMTBik3r]

26 minutes ago, hipower said:

She looks great! I almost miss it. lol

I'm not selling this back!

I just noticed that picture shows the MOS plate not seated flush with the slide. I forgot I had that issue when I first installed the optic and didn't notice until at the range that day. It is a fairly common complaint with the MOS plates, is that the included screws are either too long or too short. The screws from Glock were so long they actually raised the plate and optic away from the slide, after some reading online I went to Ace Hardware and bought some screws that were the perfect length.

 

Edited January 6, 2017 by jonathon1289

[hipower]

2 hours ago, jonathon1289 said:

I'm not selling this back!

I just noticed that picture shows the MOS plate not seated flush with the slide. I forgot I had that issue when I first installed the optic and didn't notice until at the range that day. It is a fairly common complaint with the MOS plates, is that the included screws are either too long or too short. The screws from Glock were so long they actually raised the plate and optic away from the slide, after some reading online I went to Ace Hardware and bought some screws that were the perfect length.

 

Really wasn't asking, but glad you like it. I had the same issue with the screws on the 34.

Yep, Ace is the place...in this instance.