ironsniper1

I am currently cleaning up the garage and plan to get exstension cord and one of those small heater pads and putting it on top of that on the floor on a low temp and hope for the best

With the weather being semi cold and this stuff needing to be at room temp or above to work best I am going to have to keep the parts in there for a few days to make sure it gets as much off as possible

quick update

yes i do not know how well it will work but nothing like a test

got the small items in rust remover to see how well it works

i already have one, got it back before sandy hook, i got this one for a fun project wether i shoot or just hang it on the wall i will learn something new and have fun doing it!

i found this and may give it a try https://www.youtube.com/watch?v=b-1ZbYXz2zs&t=1s

finally got the screw out! (thanks impact screwdriver!) and to be honest i think most of it will come off with a wire wheel! or i could soak some or all of it in Evapo-Rust or something

heres some more pictures they are not very good but its the best i could do

i got some pb blaster and sprayed the top receiver screw a few times before bed lastnight and this morning tried to get it out but couldnt, i will probably take a wire wheel to it and get more of the rust off and i will also buy and try a impact srewdriver and if that does not work i will have to drill that screw out which i have never done before

i figure i might get one good shot before it disintegrates into dust in my hands

will let you know as soon as i get it!

no idea it has to go through an ffl, i was going to post the link but they are now sold out

here is the bullet test

I thought about that and I might do that just got to make some room I the garage first

Nope the 20 inch barrel is all I need and as always you are a wealth of information! Thanks!

Hey everyone didn’t know where to post this, I just bought a stripped M39 receiver and want to put a M44 barrel on it but I am not sure if I need a tax stamp for a SBR or not can anyone clarify this?

True I also just bought a stripped m39 receiver that I have plans for but for this one I am just going to work on it for fun

agreed, i also posted this on another forum and someone said if the bore and whole receiver is good but the barrel is trash could just rebarrel it

someone on another forum suggested getting the barrel and action sandblasted, only issue with that is i dont know of any company that would do that especially with how guns are portrayed nowadays

just ordered a bore camera to look inside to see how it all looks, should be here tomorrow (thanks amazon prime!)

yup there is a m44 for sale at a shop not to far from me for about 415

Just gotta figure out how I’m going to do that as I have never done this before but it should be fun

I’m going to pick up some tomorrow to get the top receiver screw out, the bottom one was not to bad

Hey everyone so I bought one of the $119.99 mosins from classicfirearms and here is some pictures *WARNING* the following pictures are not for the faint of heart! You have been warned! also after wacking the bolt open with a rubber mallet I took it out and disassembled it and found that except for one part it’s in very good shape and should clean up nicely!