Jump to content

peejman

Member
  • Posts

    11,439
  • Joined

  • Last visited

  • Days Won

    17
  • Feedback

    100%

Everything posted by peejman

  1. Most amplifiers produce their maximum output at about 50%. You get clipping and/or distortion beyond that. So, I'd start by turning the volume on the head unit down to below 50% and work from there. And re-check your grounds and wire paths.
  2. That's awesome!
  3. A very good idea, but you must specifically designate the additional payment to go solely against the principal. There's usually a check box or note field where you denote this. If you don't designate it, the bank can choose where it goes and they won't choose principal. A licensed, experienced home inspector is a worthwhile investment. I also strongly encourage the prospective buyer to be present during the inspection. Follow the inspector around and ask lots of questions. Find out who built the house and their reputation. Both the realtor and home inspector should know. Be very suspicious of "owner renovated" houses in areas were permits/inspections are not required.
  4. peejman

    Ponderisms

    Funny story on that topic... What I was in school, we worked on our SAE Mini-Baja car nights/weekends in the machine shop in the basement of the engineering building. The power supply for the elevator was also in this shop. When someone would push the call button on any floor, the power relay would make a rather loud "CLACK", and the elevator would begin moving. It was loud enough that it'd startle you if you were concentrating on something. Occasionally, you'd get morons who'd push the button over and over very fast. So in the shop, we'd hear... "CLACK CLACK CLACK CLACK CLACK CLACK....". Highly annoying. One evening we'd heard this a couple of times and were tired of it. So we stopped and listened for the elevator to get to the floor the people were on. We heard the elevator stop, the doors open, the doors close, and it begin to come back down. We waited a couple seconds and opened the main breaker, killing all power to the elevator. We let it sit between floors for at least a couple minutes. We pulled the doors open on our floor and one guy who has a booming voice stuck his head in and said "YOU ONLY HAVE TO PUSH THE BUTTON ONCE!" We restored the power a moment later, which put the elevator into a reset mode in which it goes all the way to the bottom, all the way back up to the top, then back down to the main floor before stopping. We repeated that routine whenever necessary and within a short time, it became very rare for someone to repeatedly push the button. So to answer the above question, pushing the button more than once does not make the elevator arrive faster. It does however, make it reach it's destination much slower.
  5. Any of the Ruger MK series, Browning Buckmark, Beretta Neos... There's a couple of revolvers as well, but I can't think the name at the moment.
  6. Easy come, easy go. As stated, it's a buyer's market which my neighbor who just sold his house at a $20k loss will attest to. Prior thread on this topic... http://www.tngunowners.com/forums/general-off-topic/59034-homebuying-tips.html
  7. Nice renderings!
  8. Actually, I've done the "stop and stare them down" thing a few times. Mostly because I was climbing a hill that I had to pass one way or another, so simply riding away wasn't a good option. Most dogs will either back down, or stand some distance away and keep barking at you. If they don't back down, you're up ***** creek. I also have bear spray for hiking. I hope it works, but more than that, I hope I never have to find out.
  9. peejman

    Aging Steel

    That's what they mean. It's a common mispronunciation which leads to misspelling. Clorox, muriatic acid, nitric acid, ammonia, vinegar, orange juice, tomato soup, brake fluid... pretty much anything corrosive will work. It's just a matter of how much time you want to take. If you want to be semi-authentic, strip the paint and bury it a foot or so deep in the yard. Dig it up next spring.
  10. +1 to pretty much everything JReed said. Once upon a time, I was also an avid cyclist and hope to be one again at some point. I've had my share of unpleasant dog encounters. Had a few unpleasant dog owner encounters too. I wouldn't shoot one unless it was actively chewing on me (dog or owner). Otherwise, just deal with it. 1. Get more pepper spray. 2. Report repeat offenders to the authorities. 3. Ride somewhere else if 1 & 2 don't work. 4. If you don't want to ding your carbon bike, don't ride it where dogs might be. Besides, a heavier bike is better for training.
  11. What they said. A honk before it happens. Honking after doesn't accomplish anything. The finger accomplishes even less. Especially now that I have kids, I just grit my teeth, take a deep breath, and go on with life. WyattEarp's post is exactly why. There's way too many stupid people out there.
  12. Nothing, yet. Go shoot it more.
  13. I'd trade the packaged entrees and rice meals for hot dogs and smores. No bacon and eggs for breakfast? Assuming you'll have a campfire, can't go camping w/o smores... No liquid fuel? Any reason for that? All my stuff is old and runs on Coleman fuel.
  14. I've noticed the same thing. I think the biggest cause is a lack of personal accountability for mistakes. The areas where you're likely to find good craftsmanship, you're also likely to find personal accountability. Automation and cost pressures have changed a lot of things. Working used to be about doing a good job with one's hands. With automation, the ability to have any personal influence over the outcome of the job is largely removed. Which means you change from a skilled craftsman to an unskilled operator. I'm thankful to work at a place that still requires personal accountability. Folks with little pride in their work and/or poor craftsmanship typically don't last long.
  15. Good review and lots of excellent tips here: Backpacker Magazine: Outdoor Gear, Tents, Backpacks, Boots, Sleeping Bags, and more. If you don't expect to do lots of camping... the lower price scale stuff will suffice. And don't forget the toilet paper.
  16. +1 I also bought the cheapo Outers kit. I got some Hoppes #9 when I used up the solvent that came with the kit. I also got a can of CLP for when I don't have time, or just don't feel like taking stuff apart. I use the oil that came with the kit on stuff that needs oil. I use dielectric silicone spark plug boot grease on stuff that needs grease.
  17. Changing an address is easy, takes less than 5 minutes online and you don't have to get new cards unless you just want them. Print off the receipt with your new address and keep it with your DL & HCP. Since your new bride is legally changing her name, then I believe new cards are required and she'll have to process that through the DMV and Social Security office. I'd expect that would take a month or two, and I also expect there would be no issue with her carrying in the interim, provided she can produce documents that show she's done her part and is waiting on the state.
  18. An interesting study, though I'm suspicious of some conclusions that might appear obvious... Don't jump to the conclusion that your barrel will look like that 2 weeks after shooting Wolf ammo. There is no "control" identified in the study. Perhaps that's what the Wolf (a known non-corrosive primer) represents. If you do assume the Wolf is the control, then it is the baseline against which all the others should be evaluated. I think the fact that the Wolf showed some corrosion is due to the method of application, which has little correlation to actual use. You don't blast a flat plate with combusted primer products inside a barrel. The size, velocity, and hardness of the combusted primer particles likely has as much influence on the apparent amount of corrosion as anything else. When those particles hit the flat plate, they may create micro-pits in the surface due to impact. Those micro-pits are where corrosion begins. The presence of corrosive residue would accelerate the pitting, but the impact gave it a big head start. A primer that produces very hard particles will pit the surface more heavily and may show more corrosion for that reason alone and have little to do with how corrosive the residue is. It's also hard to tell if the plates themselves have corroded or if its the impacted residue on the surface. You'd have to look at the plates with a magnifier and clean them to tell what's really happening.
  19. That's not a holster, that's an anti-printing device. None for me, thanks.
  20. Welcome!
  21. Renewed mine a couple months ago, about a month before it expired. Same date + 4 years.
  22. It takes more than just an upper... http://www.tngunowners.com/forums/long-guns/59443-ar-7-62x39-russian-round.html
  23. I dispatched many, many squirrels with CB shorts growing up. They make little more noise than a high-powered air rifle.
  24. 15 acres. I believe 0.5 acre is ineligible if a dwelling is on the property. My parents have 12.5 acres and have been trying for years to buy a small piece of neighboring property to push theirs up to 15.5 so they'd qualify. Hamilton County Assessor of Property - Agriculture, Forest and Open Space Act http://www.tn.gov/attorneygeneral/op/2009/op/op09-171.pdf http://www.tn.gov/attorneygeneral/op/2010/op/op10-71.pdf

TRADING POST NOTICE

Before engaging in any transaction of goods or services on TGO, all parties involved must know and follow the local, state and Federal laws regarding those transactions.

TGO makes no claims, guarantees or assurances regarding any such transactions.

THE FINE PRINT

Tennessee Gun Owners (TNGunOwners.com) is the premier Community and Discussion Forum for gun owners, firearm enthusiasts, sportsmen and Second Amendment proponents in the state of Tennessee and surrounding region.

TNGunOwners.com (TGO) is a presentation of Enthusiast Productions. The TGO state flag logo and the TGO tri-hole "icon" logo are trademarks of Tennessee Gun Owners. The TGO logos and all content presented on this site may not be reproduced in any form without express written permission. The opinions expressed on TGO are those of their authors and do not necessarily reflect those of the site's owners or staff.

TNGunOwners.com (TGO) is not a lobbying organization and has no affiliation with any lobbying organizations.  Beware of scammers using the Tennessee Gun Owners name, purporting to be Pro-2A lobbying organizations!

×
×
  • Create New...

Important Information

By using this site, you agree to the following.
Terms of Use | Privacy Policy | Guidelines
 
We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.