O'TIERNY

I appreciate the offer. Please check your Messages!

15 minutes

This question has probably been asked in the past, but... I need some re-barreling and gas block/hand-guard/flash hider installation for a few AR-15 uppers. Anyone know of any competent, reasonably priced Gunsmiths in any of these areas? Thank in advance for any recommendations!

Agreed. I was just interested primarily in how Tennessee would proceed with a criminal case. Also, a defendant can find himself on the other side of both the Federal and State "v." What you provided earlier, though, actually answered the question I originally posted directly on point... Thanks a ton! I really appreciate it.

I'm taking my cue for proper legal measurement from the Tennessee FBI Forensic Services Division Firearms/Toolmarks Standard Operating Procedures Manual as opposed to the ATF procedure. Just my take as to what would likely be used in Tennessee.

From the Tennessee FBI Forensic Services Division Firearms/Toolmarks Standard Operating Procedures Manual - Barrel and Overall Length Measuring Procedure. Section 7.8.1 Barrel Length requires that "Barrel length normally should include compensators, flash hiders, etc. if affixed." I'm interpreting the statutory language "if affixed" as not requiring permanence.

Thanks a ton for that reply, Dave. It is very helpful.

Tennessee statutes defines a handgun as having a barrel less than 12" in length. The measurement is taken from the breech face to the muzzle, including any attached flash hiders or compensators. Is an otherwise legally configured AR-15 pistol no longer considered a pistol in Tennessee if it has a 12" or longer barrel? And, if it is no longer within the definition of pistol under Tennessee law, what is it? Definitely appreciate any helpful answers!